Products
Acobit SA150
Bitumen waterproof membrane (Self-adhesive)
Product Description
Acobit SA150 self-adhesive waterproofing membranes consists of a self- adhesive polymer modified bitumen layer coated on to a tough high density polyethylene film and protected on the other side by a release film
Advantages
-
Cold applied, self - adhesive and easy to apply
-
Excellent adhesion to vertical and horizontal surfaces
-
Improved heat resistance
-
Excellent resistance to chlorides, sulphates,
alkalis and acids -
Good tear and puncture resistance
-
Water and vapour proof
Safety and Health Protection
Acobit SA150 contains a very tacky bitumen compound and during application can adhere to human skin. Bitumen stains can be removed by using a cloth dipped in a very light solvent. In case the affected area is sensitive, like the eye, please contact the company physician for advice
Technical Specification
*All values given are subject to 5-10% variation The technical parameters are designed to be in compliance with British standard code of practice BSCP102 and BS8102. The tensile and tear strength values reported are the higher values of either longitudinal or transverse direction
Download Product Specification Sheet
Application Instructions
Surface Preparation
A smooth, regular and dry surface is always a must for good application. The substrate should be completely free of any protrusions or cavities. The presence of oily substances, frost or other moisture should be completely avoided. Apply 2 STONBIT SBP at a rate of 4-6m. Per litre as a primer coat. The primer coat should be touch dry before the application of the membrane
Application
The application temperature should be between 40C to 450C. The installation procedures are to be as follows:
​
-
Unroll only the required length, and cut the piece to the desired shape and size
-
Place the pieces of membrane on the area to be covered, and check whether they match with the profile of the marked substrate
-
Peel off the release film and carefully place the membrane so as to ensure a minimum of 75mm overlap and then smooth the membrane from the center to the edges in order to drive out entrapped air
-
Place a BITUBOARD on top of the membrane soon after the application in order to prevent any damage from exposure to sunlight, backfilling
Handling
Acobit SA150 membranes are packed in loose corrugated boxes to avoid any damage during transit or on site. The membranes can be unloaded by hand or any other convenient means, but ensure the absence of any sharp or protruding edges within close proximity to avoid puncturing the membrane
Storage
Acobit SA150 range of membranes must be stored in a shaded area on wooden pallets neatly covered by a thick fabric and tied securely in a manner that will minimize exposure to sunlight
Disposal
Acobit SA150 is a non-hazardous, non-inflammable material and therefore can be disposed of in any regular disposal area. Acobit SA150 should be disposed of only after wrapping with paper, plastic or cloth as the modified material has tendency to soften under heat and pressure, which would make further handling very difficult
For any information related to the product, please contact adchem's sales or the technical department
Contact Us
For sales and technical enquiry, please email to info@adchem.vn