top of page

Products

Acoflex 200

Cement and Polymer Based Waterproofing Membrane

“High Elastic”

Product Description

Acoflex 200 A - 20kg (1).png
Acoflex 200 A - 20kg (1).png

Acoflex 200 is a 2-component waterproofing membrane based on cement and improved Polymer with an elongation at break of about 120%, applied to waterproofing exposed areas, old or new construction works. After construction and curing, it will form a tough, flexible and high elastic waterproofing membrane for a long time; it is suitable for construction by roller, brush or sprayer

Application

  • Swimming pools, concrete or steel water tanks

  • Toilets, bathrooms, saunas, wet floors

  • Terraces, balconies, retaining walls, floors, columns

  • Bridge piers and bridge and port structures

  • Corrosion protection coating

Advantages

  • Waterproof, moisture-proof

  • Good adhesion on cement and steel surfaces

  • Good sealing of small cracks

  • Can be applied on damp surfaces

  • Creates a durable, elastic waterproof membrane

  • Allows the surface to ventilate moisture

  • Non-toxic to drinking water

Safety and Health Protection

  • Keep out of children

  • Wear gloves, mask and goggles when applying

  • Acoflex 200 contains alkalis so avoid contact with skin and eyes: If splashed into eyes: Rinse eyes with clean water for at least 10 minutes and seek medical attention promptly; If on skin: Wash immediately with soap and clean water

Technical Specification

Download Product Specification Sheet

Using Instructions

Surface Preparation

  • The concrete surface must be clean, level and hard to allow for uniform thickness application

  • Remove all contaminants that will affect the adhesion of Acoflex 200 such as grease, curing agents and concrete chips, etc.

  • The best cleaning method for large surfaces is by grinding and washing with a pressure washer

  • Defective surfaces must be repaired before application

  • Large cracks and voids must be filled with repair mortar

Mixing

Pour liquid component (A) into a clean container. Then slowly add powder component (B) and mix continuously with a low-speed mixer equipped with a mixing paddle for 2-3 minutes until the mixture is homogeneous and lump-free; then let it rest for a few minutes to reduce the foam before applying

Construction

  • Moisten the entire surface with clean water before application but do not allow standing water

  • While the surface is still damp, apply the first layer of Acoflex 200 evenly. Allow the first layer to dry and form a film, then continue to apply the second layer, interlacing with the first layer. The curing time of Acoflex 200 depends on the weather and temperature of the construction (about 3 - 4 hours)

  • No need to moisten the surface when applying the second layer

  • Apply at least two layers to achieve the desired thickness and waterproofing effect

  • Apply layers for water tanks

Note

  • Avoid construction when it is raining

  • Avoid rain and water during the curing period of the membrane

  • Do not mix the mixture more than 15 minutes before construction

  • Do not add cement or other substances when using

Cleaning Tools

Clean all tools and equipment immediately after use with clean water

Physical Parameter

For any information related to the product, please contact adchem's sales or the technical department

Contact Us

For sales and technical enquiry, please email to info@adchem.vn

bottom of page