top of page

Products

Acoflex 228

Waterproofing Compound To Mix With Cement

“Elastic“

Product Description

ACOFLEX_228_1.png
ACOFLEX_228.png

Acoflex 228 is a 1-component liquid premixed waterproofing compound, which only needs to be mixed with cement when applied. After drying, it forms a tough, flexible and elastic waterproofing membrane on concrete or cement-based surfaces

Application

  • Concrete roof, balcony, terrace

  • Wall surfaces

  • Toilet area, wet area

  • Water tank

Advantages

  • Easy to use, just mix Acoflex 228 with cement

  • Easy to apply by brush, roller or sprayer

  • Waterproof and elastic

  • Good adhesion on mortar and concrete surfaces

  • Eco-friendly

Safety and Health Protection

Technical Specification

Download Product Specification Sheet

  • Keep out of children

  • Wear gloves, mask and goggles when working

  • Avoid contact with skin and eyes: If splashed into eyes: Rinse eyes with clean water for at least 10 minutes and seek medical attention promptly; If splashed into skin: Wash immediately with soap and clean water

Using Instructions

Surface Preparation

  • The concrete surface must be clean, level and hard to allow for uniform thickness application

  • Remove all contaminants that will affect the adhesion of Acoflex 228 such as grease, curing agents and concrete chips, etc. The best cleaning method for large surfaces is by grinding and washing with a pressure washer

  • The surface must be completely saturated with water but not left standing before waterproofing

  • Defective surfaces (porous or peeling surfaces) must be repaired before application

  • Large cracks and voids must be filled with repair mortar.

Mixing

  • Use a mixer to stir the Acoflex 228 mixture thoroughly before mixing with cement. To achieve the best quality after mixing, use a low-speed electric mixer (< 500 rpm) or a forced mixer

  • Slowly pour the required amount of cement (According to the mixing ratio Acoflex 228 : Cement = 1 : 0.5) into the Acoflex 228 mixture container and continue to mix well with the mixer for about 3 minutes until the mixture is homogeneous

  • If mixing at a ratio of 1 : 1, the cement should be moistened with clean water first to avoid lumps.

Construction

  • Moisten the entire surface with clean water before construction but do not let water accumulate

  • While the surface is still damp, apply the first layer of Acoflex 228 and let it dry for about 4-8 hours (at temperatures above 20°C), then continue with the next layer. The curing time of Acoflex 228 depends on the weather and temperature of the construction site

  • Apply a minimum of 2 layers to achieve the desired thickness and waterproofing effect. Construction tools: Brush, roller or sprayer

  • Construction tools: Brush, roller or sprayer

Note

  • Concrete and mortar surfaces must be at least 14 days old before waterproofing with Acoflex 228

  • Acoflex 228 should be used up in one go after opening the container

Cleaning Tools

Clean all tools and equipment immediately after use with clean water

Physical Parameter

For any information related to the product, please contact adchem's sales or the technical department

Contact Us

For sales and technical enquiry, please email to info@adchem.vn

bottom of page