top of page

Products

Flexcell AC

High flexible Acrylic Waterproofing Membrane

Product Description

Flexcell AC is a liquid-applied elastomeric acrylic waterproofing membrane. It is formulated easily to apply by brush, roller and spraying equipment. After cure, it forms a very elastic membrane. This membrane will remain permanently elastic; it will neither shrink nor crack, and keep its colour. It is resistance to ultra violet ray and weather change. Flexcell AC has an excellent adhesion to most porous and non-porous surface

Application areas:

Flexcell AC is recommended used to waterproof and repair watertight for all roofs, gutters, eaves, balconies, walls and domes etc. to against water penetration and seepage for all weather conditions. It can be used straightaway on various kinds of substrates such as: Concrete, mortar, ferrous and non-ferrous metal, tiles, corrugated iron, plastics and bituminous felt...etc.

Technical Specification

Advantages

  • Waterproofing and weather proof

  • Low VOC

  • Cracks bridging up to 2mm

  • Environment friendly

  • Fast touch drying

  • High elongation

  • Excellent bonding on various substrates

  • Excellent for exposed application

  • Easy application and handling

  • No cracks appear on the surface after few months such as cementitious and bitumen modified products when exposed to the sunlight

Physical Properties:

Health Protection:

While working with Flexell AC materials safety goggles, gloves and safety clothing should be worn at all times. In case one of the components comes in contact with the skin, wash thoroughly with soap and water. Adequate ventilation in volume and pattern should be provided in working area. Further protection: emergency showers and eyewash stations. Please refer to Health & Safety Data Sheet for complete information

Download Product Specification Sheet

Application Instructions

Surface Preparation

Clean the surfaces; remove all debris, stones, sand, rust etc. surfaces must be dry and sound. Fill all cracks with repair mortar, cement grout or sealant

Priming:

The surfaces should be primed with Acobond A530 Primer, allowed to dry and tested for adhesion. In case there are joints, fill one layer of fibre–glass-mat cover the joint in between two coatings is recommended

Application:

Wait until the primer coat cured but still sticky. Apply the first coat of Flexcell AC over the primer coat, then wait until it cured completely continues apply the second coat or the third coat. If the surfaces has protected with mortar or tiles: It must spread a layer of clean, dry sand on the last coat of Flexcell AC surface to crease a porous bonding bridge

Consumption:

  • 0.8 – 1.2kg/1m² . (Without fibreglass reinforcement)

  • 2 1.5 – 1.7kg/1m² . (With fibreglass reinforcement)

Limitation:

Avoid water and raining during the application and curing time
Avoid permanent traffic on the surface of Flexcell AC during the cure time
The construction site must be good ventilation condition

Cleaning Tools:

While working with Flexcell AC materials safety goggles, gloves and safety clothing should be worn at all times. In case one of the components comes in contact with the skin, wash thoroughly with soap and water. Adequate ventilation in volume and pattern should be provided in working area. Further protection: emergency showers and eyewash stations. Please refer to Health & Safety Data Sheet for complete information

For any information related to the product, please contact adchem's sales or the technical department

Contact Us

For sales and technical enquiry, please email to info@adchem.vn

bottom of page