Products
Flexcem 230
High Flexible Cementitious Waterproofing Membrane
Product Description
Flexcem 230 is a liquid-applied 2-component high flexible cementitious waterproofing membrane. It is recommended to use for internal and external, old and new construction waterproofing. The coating of Flexcem 230 after setting will form a hard, tough and highly flexible waterproofing membrane. Flexcem 230 has been formulated easily to apply by brushing, rolling and spraying
Application areas:
-
Water tank, swimming pool and basement wall
-
Bath room, rest room, kitchen and laundry areas
-
Balcony, corridor and wet areas
-
Concrete pipes, sewers, manholes
-
Bridge piers and other bridge structures
Advantages
-
Excellent waterproofing and damp-proofing
-
Resistant to alkaline and various chemicals
-
Bridging hairline cracks
-
Resistant to frost and thawing salts
-
Excellent adhesion on moist surfaces
-
Non-toxic, non-corrosive
-
Environment friendly product
Health Protection:
-
Safety goggles, rubber gloves, safety mask and clothing should be worn at all time
-
Avoid contact with eyes and prolonged contact with skin. In case of contact, flush eyes with plenty of clean water for at least 10 minutes and get prompt medical attention; wash skin thoroughly with soap and water
-
Keep out of reach of children. Please refer MSDS
Technical Specification
Physical Properties:
Download Product Specification Sheet
Application Instructions
Preparation of Substrates:
-
The substrates must be clean and sound. Remove all the contaminants and loose particles of concrete
-
The surfaces should be washed with jet water to clean away dirt or dust
-
Repair all holes, cracks by mortar with Acobond A38 additive. Seal all the joints and gap by Elastoseal P100 Sealant
-
Apply angles fillets to floor and wall, vertical corners between two walls. These fillets should be formed by using repair mortar with Acobond A38 additives or Acofill M50
Mixing:
-
Pour the liquid component into a clean barrel then slowly add the powder component to mix. Mix well thoroughly by a driller with suitable paddle from 300 to 600 rpm. The mixture should be mix until homogenous and free of lumps. Let the mixture rest about few minutes then slowly remix again and use
-
The gel time and cure times is depending on the temperature and humidity. Gel times range from 30 minutes to 60 minutes
Application:
-
Prior to the application, the surfaces should be saturate with clean water and keep damp. Any surface stagnate water should be swept away. Apply the well-mixed Flexcem 130 onto the prepared substrate from the top to the bottom. Do not apply too thick more than 1.5 mm per layer. The next layer can be applied as soon as the first layer dry enough, but it is recommended to wait at least 6 hours
-
It is better to apply the first layer with vertical direction and the second layer is in horizontally, if the application is carried out by brush
-
Protect the applied surface avoid contact with water during the drying time. Protect the surface avoid traffic wearing
Cleaning Tools:
Clean the tools and mixing equipment immediately with water before setting. Hardened material can only be removed by mechanically
For any information related to the product, please contact adchem's sales or the technical department
Contact Us
For sales and technical enquiry, please email to info@adchem.vn