top of page

Products

Floorseal SH300

Concrete Floor Hardener

Product Description

Floorseal SH300 is a water-based floor hardener based on lithium silicate, non VOC and eco-friendly. It is used to protect surfaces, prevent abrasion and prevent dust, applied on concrete floors to resist the friction of rubber wheels and high-density pedestrians. It penetrates deep into the pores of the concrete surface, interacts with excess lime to form an insoluble crystalline compound, seals the capillaries of the concrete, making the concrete surface more solid and hard, resistant to abrasion, dust generation, and protects the surface against the erosion of oil, grease, water, impurities and dirt

Application

  • Floorseal SH300 is recommended for new or old concrete floors such as:

  • Supermarkets, Distribution Centers, Showrooms, Parking Lots, Warehouses, Factories

  • Car Service Workshops, Manufacturing Facilities, Grocery Stores, Shopping Mall

  • Stadiums, Pharmaceutical Plants, Textile Plants, Breweries, Food Processing Plants

  • Dairy Plants, Canning Plants, Restaurants, Cafes, School Yards, Mechanical Workshops

Advantages & Benefits

  • Eco-friendly, non VOC

  • Increases concrete compressive strength

  • Increases abrasion and impact resistance

  • Increases the density of concrete surfaces

  • Dustproof, reduces dust accumulation and easy to clean

  • Long-last shinine finishing

  • Low maintenance costs

Specification

Download Product Specification Sheet

Safety and Health Protection

Mechanical Parameters

  • Floorseal SH300 is an alkaline product, so avoid contact with skin and eyes. If contact with skin, wash immediately with clean water. If contact with eyes, use a large amount of clean water to rinse eyes several times, use eye drops and go to a medical facility immediately, health protection methods are all listed in the product safety data

  • When applying by sprayer, avoid breathing water mist

  • Protective glasses, gloves and rubber boots must be worn during application

Using Instructions

Surface Preparation

Existing concrete:

  • Concrete must be clean, free of dust, oil, grease, paint or other contaminants that may affect penetration

  • Cracks and voids must be filled with adchem's Acotop product

New concrete:

  • New concrete must be cured for at least 72 hours. Ideally, concrete should be cured for 7 days

  • Removal of concrete curing agents or other coatings may affect the penetration of Floorseal SH300

Construction Steps

  • Apply one layer of Floorseal SH300 to saturate the concrete floor surface by spraying or pouring. The concrete floor will absorb the solution within 1 hour. Apply the second layer when the surface has completely absorbed the first layer (in case of highly absorbent surfaces). After the second layer is completely dry, use a cleaning machine and rinse off any excess material and powder on the floor surface. If you don't follow this instruction, the floor may in loss of gloss, abrasion and slipperiness when exposed to water

Floor polishing:

  • Wait for Floorseal SH300 to dry completely within 1 to 2 days. Use a professional floor polishing machine, polishing with different pad levels

  • After finishing the polishing process, clean with clean water, industrial cleaning machine and vacuum

Notes and limitations:

  • Only apply on concrete surfaces above 5°C

  • New concrete must be finished with a power trowel

For any information related to the product, please contact adchem's sales or the technical department

Contact Us

For sales and technical enquiry, please email to info@adchem.vn

bottom of page