top of page

Products

Nanocryst PX100

Crystalline Penetrating Waterproofing Compound

Nanocryst_PX100.png
Nanocryst_PX100.png

Product Description

Nanocryst PX100 is a crystalline waterproofing product that penetrates deep into the concrete, reacts with free lime and water, forming insoluble complex crystalline fibers that seal capillaries and cracks in concrete. It seals shrinkage cracks up to 0.4mm

Application

  • Basement foundations and load-bearing walls

  •  Underpasses, vaults, elevator shafts

  • Water tanks (drinking water), wastewater treatment tanks

  • Water pipes, manholes, aquaculture tanks

  • Underground structures

Technical Specification

Advantages

Download Product Specification Sheet

  • Non-toxic, odorless, environmentally friendly

  • Non-toxic to drinking water, Chloride-free

  • Easy to use, just mix with water

  • Can be applied to live concrete after demoulding

  • Protects concrete against water, salt water, wastewater and water pressure from the ground

  • Protects concrete in depth even when the coating is damaged

  • Suitable for positive and negative surfaces

  • Long-lasting effect

  • Can increase the strength of concrete

  • Resistant to corrosive chemicals and freeze-thaw cycles

Using Instructions

Surface Preparation

  • Clean off all grease, concrete curing agents, cement mortar, concrete debris and other contaminants

  • The best cleaning method for large surfaces is with a water pressure washer. Large cracks and voids in the concrete must be filled with mortar before application. Create a clean, flat and hard concrete surface. Before application, dampen the entire surface but do not allow standing water

Mixing

  • Use a hand mixer with a suitable mixing paddle at a speed of about 400 to 600 rpm

  • Pour the measured amount of water into a clean container. Slowly pour in the powder and stir until it dissolves without lumps. Continue adding the remaining water and mixing until it is homogeneous (mix for about 3 to 5 minutes). Let the mixture rest for about 1 minute, mix lightly again and then apply

Construction

Apply by sprayer:

  • Water quantity: 8 liters of water for 25kg bag

  • Material consumption: 2 kgs per m2 Pour the premixed Nanocryst PX100 mixture into the sprayer, adjust the pressure and spray head to suit the construction dosage. Spray onto the concrete while it is still damp

Apply by brush:

  • Water quantity: 6-7 liters of water for 25kg bag

  • Material consumption: 2 kgs per m² While the surface is still damp, apply the first layer of Nanocryst PX100 evenly with a brush. Wait for the surface to dry and no longer stick to your hands for about 6 hours, then apply the second layer

Apply by trowel:

  • Water quantity: 4-5 liters of water for 25kg bag

  • Material consumption: 2 kgs per m² While the surface is still damp, apply the first layer of Nanocryst PX100 with a plastic or steel trowel. Wait for the surface to dry for about 6 hours, then apply the second layer

Apply by dry spreading:

  • Material consumption: 2 kgs per m²
    Spray water to moisten the floor surface before construction. Spread Nanocryst PX100 onto the surface of the product according to the construction rate; then pour fresh concrete onto the Nanocryst PX100 layer, the water in the concrete will disperse the Nanocryst PX100 powder and penetrate into the concrete to form a complete waterproof layer for the concrete

Note

  • Wear a mask, goggles and protective clothing when working

  • Clean all tools immediately after use with clean water

Physical Parameter

For any information related to the product, please contact adchem's sales or the technical department

Contact Us

For sales and technical enquiry, please email to info@adchem.vn

bottom of page