Products
Stonflex 136R
Positive and Negative Side Cementitious Waterproof Coating
Description
Stonflex 136R is a two component polymer modified cementitious coating. It is specifically designed to waterproof and damp-proof for positive and negative side of above and below ground concrete and masonry construction. It has conformed to FDA (US)-21 CFR 175.300-resinous and polymeric coating used as food-contact surface of articles intended for holding food. Suitable for use in potable water tanks
Uses
Stonflex 136R is used to waterproof and protective for:
-
Tunnels. Basements. Foundation. Elevator. Pits
-
Reservoirs. Swimming Pools. Aqueducts
-
Retaining Walls. Sea Walls, Dam Breasts,
Bridge Piers. Column -
Stonflex 136R has consistently proved its effectiveness against underground (negative side) water pressure
Features and Benefits
-
Excellent Waterproof and damp-proof
-
Permanently bond to cementitious or masonry substrates, even after long periods of immersion condition
-
Good hairline cracks (fine) bridging
-
Able to withstand hydrostatic water pressure
-
Can be applied onto damp concrete
-
High strength, great durability
Storage
Powder component: Store in dry place and avoid humidity Store above pallet when not immediately use
Liquid component: Store in cool place avoid direct from sunlight and frozen Tightly seal unused portion and use it all as soon as possible. Unopened product will store for a minimum 12 months under normal weather condition
Technical Specification
Download Product Specification Sheet
Safety Precautions
When mixing or handling the dried product wear suitable respiratory protection, gloves and eye/face masks. Do not inhale dust. Mix in a well- ventilated area
Avoid contact with eyes and prolonged contact with skin. In case of contact, flush eyes with plenty of clean water for at least 10 minutes and get prompt medical attention; wash skin thoroughly with soap and water
Keep out of reach of children
Direction For Use
Surface Preparation
The surface must be cleaned and hardened, removed from grease, cured concrete, mold, dust and cement grout. Repair places where the surface is uneven or pitted. Large cracks must be filled with repair mortar with Acobond A38 additive
Mix
Apply with a brush or sprayer
Empty the solution ingredient (A) into a clean container; then stir, while slowly adding the flour ingredient (B) and mixing well. Mix continuously with a drill with a mixer attachment for 3-5 minutes until the mixture forms a homogeneous mass that does not clump. Let the mixture rest for a few minutes, stir gently again and apply (it is possible to reduce the powder content by 5-10% when mixing to be suitable for application with a sprayer)
Construction by flying plaster
Reduce the solution composition by about 10%, put it in a clean container; then stir, while slowly adding the flour ingredient (B) and mixing well. Mix continuously with a drill with a mixer attachment for 3-5 minutes until the mixture forms a homogeneous mass that does not clump. Let the mixture rest for a few minutes, stir gently again and then apply (use 10% of the solution composition to further adjust the consistency to suit when applying)
Construction
Moisten the entire surface before and during construction but do not allow water to stagnate. To avoid scratching the first layer, it is recommended to apply the second layer when the surface of the first layer has dried
There is no need to re-moisten the surface before applying the second layer. Apply the second layer vertically from top to bottom diagonally perpendicular to the first. Do not apply when the weather is sunny or windy or the temperature is above 400C and below 50C
Remark
Construction of at least two layers. Do not mix the mixture before use for more than 30 minutes.
Do not mix cement or other chemicals when using
Cleaning
Clean all tools and equipment immediately after use.
For any information related to the product, please contact adchem's sales or the technical department
Contact Us
For sales and technical enquiry, please email to info@adchem.vn